Which parts of the cylindrical grinder need to be lubricated and the use of the grinding wheel?


Cylindrical grinder is a very common grinder. The equip […]

Cylindrical grinder is a very common grinder. The equipment is mainly used to grind some large parts, especially the inner holes and end faces of some parts. This kind of grinder can meet the processing of many parts. Requirements, such as the processing of parts such as grinding wheels and protective covers, cylindrical grinders need to timely check the oil volume of the equipment and the water level in the cooling tank during processing.

When the amount of water and oil in the water tank of the cylindrical grinder is insufficient, it needs to be added in time. During processing, the processed parts need to be trimmed in time, and then the normal use can be started only after the inspection is performed. In the process, sharp diamonds should be used for dressing, and coolant should also be used.

The relative position between the grinding tool axis and the spindle center of the cylindrical grinder needs to be adjusted in time, and then tightened with a nut. The equipment can realize one-time clamping, and the end face and inner hole can be ground during processing. For processing, the precision of the guide rail is very high when in use, and it has very good vibration resistance, and the equipment can achieve AC frequency conversion when it is rotating.

The lubricated parts of the cylindrical grinder are all automatically lubricated. This saves a lot of lubrication working time. There will be a sealed cover inside the equipment, so it can play a very good protective role. At that time, the equipment can adjust the position of the stroke stop according to the length of its grinding, and it needs to be tightened in time after adjustment.

Cylindrical grinders need to check the grinding wheel in time before using the grinding wheel. If there are cracks on the surface of the product, it cannot be used. After installation, a balance experiment needs to be carried out, and then it is idling for a few minutes to compare the movement of the product. It is stable, so the noise emitted will be relatively small. The equipment system is a closed loop pipeline, so it is difficult to diagnose a fault.